FCPS foam insert waterRO BIG BLUE 10" with a precision of 10 microns for mechanical water filtration. Effectively traps sediments and fine solid particles (silt, sludge), supporting the protection of installations and more expensive inserts (e.g., carbon, softening, iron removal). Fits BIG BLUE 10" housings.
WodaRO FCPS10BB10 is a foam filter cartridge BIG BLUE 10" with 10 micron precision, designed for mechanical water filtration. It effectively removes silt, sludge and other fine solid particles, supporting the water filtration system and protecting the installation, fittings and subsequent treatment stages. This is a practical water filter for BIG BLUE 10" housings, used both in under-sink and in-line systems, also as protection for solutions such as reverse osmosis filter or other cartridges operating in the water treatment process.

FCPS10BB10 from the WodaRO BIG BLUE series has been designed to remove mechanical contaminants, i.e. sedimentary deposits present in water. The 10 micron filtration precision means that the cartridge very effectively captures fine fractions of solid contaminants such as silt, sludge and similar suspensions.
Such contaminants can occur both in well water and in mains water, where they often appear during transport. Using the cartridge helps improve water quality at the pre-filtration stage and limits the passage of deposits to further elements of the system.
The cartridge is made of high-quality foam, i.e. polypropylene nonwoven fabric. The material has been formed so that the water is filtered through the entire structure of the cartridge, not only on its surface. As a result, filtration is effective and uniform throughout the entire volume of the filter medium.
This design is especially useful where it is necessary to retain deposits before subsequent treatment stages. In practice, this means better protection of more advanced and more expensive cartridges and a lower risk of contamination of installation components.
The BIG BLUE 10" foam cartridge is used in various filtration systems where effective mechanical water filtration is needed.
It is a good choice wherever effective pre-treatment of water and extended service life of subsequent system components matter. The cartridge can also work as a pre-stage in systems where reverse osmosis, an osmosis filter or another reverse osmosis system is used later and requires protection against mechanical particles.
The cartridge is intended for BIG BLUE 10" housings. The actual service life depends on the quality of the feed water and the amount of contaminants retained. With a higher level of deposits, replacement may be needed sooner.
To maintain high filtration efficiency, the cartridge should be replaced regularly, in line with the operating conditions of the system. The FCPS10BB10 model can operate for up to 6 months, however the operating time depends directly on the quality of the incoming water.
If the water contains larger amounts of silt, sludge or other deposits, the cartridge may wear out faster. A noticeable drop in flow, increased operating resistance or reduced effectiveness of mechanical filtration may indicate the need for replacement.
* Cartridge service life depends on the quality of the incoming water.
| Cartridge height | 10'' |
|---|---|
| Cartridge diameter | 4.5" |
| Filtration precision | 10 micron |
| Service life | up to 6 months* |
| Pressure drop | 0.2 - 0.4 bar |
| Housing type | BIG BLUE 10" |
| Material | foam / polypropylene nonwoven fabric |
| Intended use | mechanical water filtration, removal of deposits and fine solid particles |
The FCPS10BB10 model is intended for BIG BLUE 10" housings.
The cartridge retains mechanical and sedimentary contaminants, including fine solid particles such as silt, sludge and similar deposits present in water.
Yes, the cartridge is suitable for filtering water from a private well, especially where fine mechanical deposits are present.
Yes. The cartridge also works well in mains water, where mechanical contaminants may appear during transport in the installation.
The expected service life is up to 6 months, but the actual period of use depends on the water quality and the amount of contaminants retained.
The filtration precision is 10 micron, which allows it to effectively capture fine mechanical contaminants.
It most often works as pre-filtration. It protects subsequent treatment stages such as carbon, softening and iron removal cartridges, as well as installation components and fittings.
Yes, as a mechanical filtration stage it can support the protection of devices such as an osmosis filter or reverse osmosis system, limiting the flow of deposits to further elements of the system.
The cartridge is made of high-quality foam, i.e. polypropylene nonwoven fabric, which filters water through the entire structure of the cartridge.
The pressure drop is 0.2 - 0.4 bar.
FCPS foam insert waterRO BIG BLUE 10" with a precision of 10 microns for mechanical water filtration. Effectively traps sediments and fine solid particles (silt, sludge), supporting the protection of installations and more expensive inserts (e.g., carbon, softening, iron removal). Fits BIG BLUE 10" housings.